Delta 20-621 4-Inch Drill Press Vise

Additional Delta 20-621 4-Inch Drill Press Vise Information

What Customers Say About Delta 20-621 4-Inch Drill Press Vise:

While this vise might not fit on all drill presses, it fit on my Rikon product since it has eight slots in the table. I use another, smaller vise clamped into this one when I need to hold rods vertically or other things more securely (since the other vise is much higher quality, but smaller capacity). This vise is about what you'd have to expect for twenty bucks. I can usually only get two bolts in, but that is more than enough to hold it in place. Gives me a poor man's "X-Y" vise. Fit and finish is mediocre, but it does the job of holding something securely while drilling. Definitely beats trying to use your hand.

It was received timely and in good condition, but I sent it back, as it did not fit my drill press, if it did, I would have kept it.

The casting is heavy and the screw operates smoothly. Also, the jaws are a bit too narrow for a lot of what I might use the thing for.Basically its a bad idea that is really well made. I bought this vice soon after I bought my drill press thinking it would be a much needed accessory. The main issue is that it is a pain to attach to the drill press table and also a pain to make adjustments to once it is attached. If you can think of a good use for it, then by all means buy it for its quality and price - otherwise forget it. I was wrong. I think I have used this thing twice in five years.There is nothing wrong with this tool.